Archive for the 'cisco' Category



To reset a Cisco Catalyst 2948G switch to factory defaults do the following:
[NB: This will RESET the switch to factory settings!]
1. Connect via serial to console port (Use these terminal settings-9600 baud rate/No parity/8 data bits/1 stop bit)
2. Turn off the switch, and then turn the switch back on
      Wait a few minutes after the power […]




About

You are currently browsing the RunningWithBulls.com - The curse of Sanfermin weblog archives for the 'cisco' category.

Longer entries are truncated. Click the headline of an entry to read it in its entirety.
Categories:

NetNewsWire: More news, less junk. Faster